John Matt
2018-11-28 01:37:28 UTC
Hi All,
I am following instructions located in the following link:
https://github.com/qoriq-open-source/yocto-sdk
Everything was good (in fact I can boot the linux), but when I issue
following command, I get fsl-mc:ERROR Bad DPL image as follows (screen shot
is attached). Any ideas ? I am just straightforward following instructions
from https://github.com/qoriq-open-source
fsl_mc apply dpl 0x80200000
[image: image.png]
I am following instructions located in the following link:
https://github.com/qoriq-open-source/yocto-sdk
Everything was good (in fact I can boot the linux), but when I issue
following command, I get fsl-mc:ERROR Bad DPL image as follows (screen shot
is attached). Any ideas ? I am just straightforward following instructions
from https://github.com/qoriq-open-source
fsl_mc apply dpl 0x80200000
[image: image.png]